TM 9-2320-363-34-2
14. STACK 10 CLUTCH PLATES (11 AND 12) ON FLAT SURFACE OF PRESS STARTING WITH STEEL
PLATE (11) AND ALTERNATING WITH FRICTION PLATE (12).
15. PLACE FOURTH CLUTCH DRIVING HUB (13) ON CLUTCH PLATES (11 AND 12).
NOTE
Apply pressure to clutch pack to steady clutch pack.
16. PRESS EVENLY ON FOURTH CLUTCH DRIVING HUB (13) WITH 100 PSI (689.5 kPa).
17. MEASURE DISTANCE FROM BASE OF CLUTCH PACK (14) TO MACHINED SURFACE (15) OF
FOURTH CLUTCH DRIVING HUB (13) TO DETERMINE CLUTCH PACK THICKNESS.
18. IF FORWARD CLUTCH PISTON (10) IS Z PISTON, CLUTCH PACK THICKNESS MUST BE
1.415-1.442 IN. (35.94-36.63 mm). IF FORWARD CLUTCH PISTON (10) IS Y PISTON, CLUTCH
PACK THICKNESS MUST BE 1.388-1.414 IN. (35.26-35.92 mm). IF FORWARD CLUTCH PISTON (10)
IS X PISTON, CLUTCH PACK THICKNESS MUST BE 1.361-1.387 IN. (34.57-35.23 mm). REPLACE
CLUTCH PLATE(S) (11 AND 12) AS NEEDED TO ENSURE PROPER CLUTCH PACK THICKNESS.
19. REMOVE CLUTCH PACK (14) AND FOURTH CLUTCH DRIVING HUB (13) FROM PRESS.
14-65
