TM 9-2320-363-34-2
W A R N I N G
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in well-ventilated area, If
adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
To prevent injury, compressed air will not exceed 30 psi (207 kPa). Use
I
only with effective chip guarding and personal protective equipment,
goggles, shield, and gloves.
2.
IF THERE IS LEAKAGE AT BOTTOM SIDE OF HOUSING OR IF BALLS DO NOT MOVE FREELY,
CLEAN BALL POCKETS (1) WITH DRYCLEANING SOLVENT AND DRY WITH COMPRESSED AIR.
3.
APPLY LUBRICATING OIL AROUND AREA OF BALL POCKETS (1).
1.
INSPECT ALL PARTS FOR WEAR OR DAMAGE.
2.
TURBINE SHAFT IS PRESSED IN FORWARD CLUTCH HOUSING AND SHOULD BE TIGHT.
REPLACE FORWARD CLUTCH HOUSING IF THERE IS ANY UP AND DOWN MOVEMENT.
3.
REPLACE ALL 20 PISTON RELEASE SPRINGS IF ANY 3 SPRINGS DO NOT MEET FOLLOWING
LOAD-HEIGHT REQUIREMENTS:
LENGTH WITHOUT LOAD: 1.2 IN. (31.8 mm).
LENGTH UNDER LOAD: 0.88 IN. (22.4 mm) WITH LOAD OF 17.9 -18.9 LB (8.13-8.58 kg).
Use general repair methods to repair damaged parts (page 2-33).
14-61
