TM 9-2320-363-34-2
FORWARD CLUTCH AND HOUSING REPLACEMENT AND REPAIR (CONT)
2.
3.
4.
5.
6.
INSTALL FOURTH CLUTCH ALINING TOOL (6) ON FOURTH CLUTCH ASSEMBLY (4).
W A R N I N G
To prevent injury, compressed air will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personal protective equipment, goggles,
shield, and gloves.
APPLY AIR PRESSURE TO PORT (7) TO LOCK UP FOURTH CLUTCH PLATES.
HOLD AIR PRESSURE IN FOURTH CLUTCH ASSEMBLY (4) AND REMOVE FOURTH CLUTCH
ALINING TOOL (6).
CONTINUE TO APPLY AIR PRESSURE IN FOURTH CLUTCH ASSEMBLY (4) WHILE HOLDING
TURBINE SHAFT (8) AND INSTALL FORWARD CLUTCH ASSEMBLY (9) IN TRANSMISSION
HOUSING (5).
STOP APPLYING AIR PRESSURE WHEN FORWARD CLUTCH ASSEMBLY (9) IS FULLY SEATED
IN TRANSMISSION HOUSING (5).
NOTE
Follow-on Maintenance:
Install torque converter housing and front support (page 14-35).
14-70
