TM9-2320-363-34-2
FAN CLUTCH REPAIR
This task covers:
a. Disassembly
b. Cleaning
c. Inspection d. Assembly
INITIAL SETUP
Applicable Configuration:
All except M915A2 and M916A1
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
Materials/Parts:
W A R N I N G
Kit, Repair
P/N 1033-05435-03
Kit, Seal
P/N 1033-07781-01
Seal, Dust
P/N 3018-01519-01
References:
TM9-2320-363-20
Equipment Condition:
Reference
Condition Description
TM9-2320-363-20
Fan Clutch Removed
General Safety Instructions:
Housing is under spring tension. Use suitable
clamps to hold housing and shaft assembly in
place while removing cylinder. Failure to do so
could result in injury to personnel.
D I S A S S E M B L Y
NOTE
Note position of seal for assembly.
1.
REMOVE LOCK NUT (1) TAB WASHER (2) CYLINDER (3) SEAL (4) PACKING (5) AND DUST SEAL
(6) FROM CLUTCH ASSEMBLY (7). DISCARD LOCK NUT. TAB WASHER, SEAL, PACKING, AND
DUST SEAL
W A R N I N G
Housing is under spring tension. Use suitable C clamps to hold housing and
shaft assembly in place while removing cylinder. Failure to do so could result in
injury to personnel.
2.
INSTALL TWO C CLAMPS ON OPPOSITE SIDES OF CLUTCH ASSEMBLY (7).
3.
REMOVE SIX SCREWS (8) SIX LOCK WASHERS (9) THREE RETAINING PLATES (10), AND LINING
(11) FROM SHAFT ASSEMBLY (12). DISCARD SCREWS, LOCK WASHERS, AND LINING.
4.
RELEASE C CLAMPS SLOWLY TO RELIEVE SPRING TENSION AND REMOVE HOUSING (13)
SEAL (14) END CAP (15) AND SPRING (16) FROM SHAFT ASSEMBLY (12). DISCARD SEAL AND
SPRING.
12-207.0 Change 1
