TM 9-2320-363-34-2
Inspect fan drive shaft and clutch for galling, pitting, scoring, or cracks. Replace as necessary.
1.
2.
3.
IF REMOVED, INSTALL SIX NEW STUDS (19) IN HOUSING (13).
INSTALL PISTON ASSEMBLY (16) AND RETAINING RING (17).
INSTALL NEW SPRING (16) END CAP (15), NEW SEAL (14), AND HOUSING (13) ON SHAFT
ASSEMBLY (12).
4.
COMPRESS HOUSING (13) AND SHAFT ASSEMBLY (12) TOGETHER USING TWO “C” CLAMPS
AND INSTALL NEW LINING (11), THREE RETAINING PLATES (10), SIX NEW LOCK WASHERS (9)
AND SIX NEW SCREWS (8) IN SHAFT ASSEMBLY (12).
5.
REMOVE TWO “C” CLAMPS FROM OPPOSITE SIDES OF CLUTCH ASSEMBLY (7).
6.
INSTALL NEW DUST SEAL (6), TWO NEW PACKINGS (5 AND 4), CYLINDER (3), NEW TAB
WASHER (2) AND NEW LOCK NUT (1) ON CLUTCH ASSEMBLY (7).
12-207
