TM9-2320-363-34-2FAN CLUTCH REPAIRThis task covers:a. Disassembly b. Cleaning c. Inspection d. AssemblyINITIAL SETUPApplicable Configuration:Equipment Condition:M915A2 and M916A1ReferenceCondition DescriptionTools and Special Equipment:TM9-2320-363-20Fan Clutch RemovedShop Equipment, SC 4910-95CL-A31Tool Kit, SC 5180-90-CL-N05Materials/Parts:General Safety Instructions:W A R N I N GKit RepairSeal, DustReferences:TM9-2320-363-20P/N 1033-05435-02P/N 3018-01519-01Housing is under spring tension.Use suitable clamps to holdhousing and shaft assembly inplace while removing cylinder.Failure to do so could result ininjury to personnel.1.REMOVE LOCK NUT (I), TAB WASHER (2) CYLINDER (3), TWO PACKINGS (4 AND 5) ANDDUST SEAL (6) FROM CLUTCH ASSEMBLY (7). DISCARD LOCK NUT, TAB WASHER, PACKINGS,AND DUST SEAL.WARNINGHousing .is under spring tension. Use suitable “C” clamps to hold housing andshaft assembly in place while removing cylinder. Failure to do so could resultin injury to personnel.2.INSTALL TWO “C” CLAMPS ON OPPOSITE SIDES OF CLUTCH ASSEMBLY (7).3.REMOVE SIX SCREWS (8) SIX LOCK WASHERS (9), THREE RETAINING PLATES (10), ANDLINING (11) FROM SHAFT ASSEMBLY (12). DISCARD SCREWS, LOCK WASHERS, AND LINING.4.RELEASE “C” CLAMPS SLOWLY TO RELIEVE SPRING TENSION AND REMOVE HOUSING (13) SEAL(14), END CAP (15), AND SPRING (16) FROM SHAFT ASSEMBLY (12). DISCARD SEAL AND SPRING.5.REMOVE RETAINING RING (17) AND PISTON ASSEMBLY (18).6.IF DAMAGED, REMOVE AND DISCARD SIX STUDS (19) FROM HOUSING (13).Use general cleaning methods to clean all parts (page 2-30)12-206Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
