TM 9-2320-363-34-2
1.
2.
3.
4.
5.
6.
C A U T I O N
Be careful not to damage center housing bore with retaining ring pliers when
installing retaining rings.
INSTALL NEW RETAINING RING (1) IN TURBINE END OF CENTER HOUSING (2).
COAT JOURNAL BEARING (3) WITH ENGINE OIL. INSTALL JOURNAL BEARING (3) AND NEW
RETAINING RING (4) IN TURBINE END OF CENTER HOUSING (2).
C A U T I O N
Be careful not to damage center housing bore with retaining ring pliers when
installing retaining ring.
INSTALL NEW RETAINING RING (5) IN COMPRESSOR END OF CENTER HOUSING (2).
COAT NEW JOURNAL BEARING (6) WITH ENGINE OIL. INSTALL JOURNAL BEARING (6) IN
COMPRESSOR END OF CENTER HOUSING (2).
FIT NEW THRUST BEARING (7) INTO GROOVE OF THRUST COLLAR (8). INSTALL THRUST
COLLAR (8) ON CENTER HOUSING (2). SECURE THRUST COLLAR AND BEARING WITH THREE
NEW SCREWS (9). TIGHTEN SCREWS TO 30-35 LB-IN. (3.4-3.9 N.m).
I
C A U T I O N
Do not force piston ring into place as it is easily broken.
INSTALL NEW PISTON RING (10) ON THRUST COLLAR (8) BY HAND.
12-177