TM 9-2320-363-34-2
TURBOCHARGER REPAIR (CONT)
C A U T I O N
Be careful not to damage center housing bore with retaining ring pliers when
removing retaining ring.
14. REMOVE AND DISCARD COMPRESSOR END JOURNAL BEARING (23) AND RETAINING RING (24)
FROM COMPRESSOR END OF CENTER HOUSING (2).
15. REMOVE TURBINE END RETAINING RING (25), JOURNAL BEARING (26), AND RETAINING RING
(27) FROM TURBINE END OF CENTER HOUSING (2). DISCARD RETAINING RINGS.
16. REMOVE OIL INLET CONNECTOR (28) FROM CENTER HOUSING (2).
Use general cleaning methods to clean all parts (page 2-30).
I N S P E C T I O N
1.
INSPECT ALL PARTS FOR SIGNS OF DAMAGE, CORROSION, OR DETERIORATION. CHECK FOR
NICKED, CROSSED, OR STRIPPED THREADS.
2.
VISUALLY CHECK TURBINE WHEEL SHROUD AND TURBINE WHEEL FOR SIGNS OF RUBBING.
3.
CHECK COMPRESSOR WHEEL FOR SIGNS OF RUBBING OR DAMAGE FROM FOREIGN
MATERIAL. WHEEL MUST BE FREE OF DIRT AND OTHER FOREIGN MATERIAL.
12-176