TM 9-2320-363-34-1
NOTE
If rocker arms are reused, install in previously determined order.
Logo on rocker arm shaft must be on outboard (front and rear) when seated.
5.
LUBRICATE ROCKER ARM BUSHING WITH CLEAN ENGINE LUBRICATING OIL. INSTALL THREE
ROCKER ARM ASSEMBLY SETS (EXHAUST (11), INTAKE (12), AND INJECTOR (13)) ON ROCKER
ARM SHAFT (10 WITH LOGO (14) STAMPED ON END OF SHAFT (10).
6.
USING ROCKER STUD SOCKET (15), CHECK TIGHTNESS OF ROCKER ARM SHAFT STUDS (16)
IN CAM CAPS (17) NO. 1 AND NO. 7. TIGHTEN STUDS TO 75-86 LB-FT (101-116 N.m).
3-191
