TM 9-2320-363-34-1
CAUTION
Turn accessory drive in clockwise direction only when barring engine over to
prevent damage to equipment.
l
l
l
l
l
NOTE
Using following method, it will only be necessary to bar engine over two
complete revolutions. Three cylinders are adjusted, either valves or injectors,
on each revolution.
To adjust valves and set fuel injector height, bar engine over until one fuel
injector begins its downward stroke. Adjust all valves (two intake, two exhaust)
at this cylinder position and set fuel injector height on companion cylinder
shown on timing circle chart.
Never set valves and injector of same cylinder at same time.
Bar engine over in clockwise direction until fuel injector for next cylinder shown
in timing circle chart begins its downward stroke. Adjust valves for this cylinder
and set fuel injector height for companion cylinder shown on timing circle chart.
Continue around timing circle chart until six sets of valves and fuel injectors
have been adjusted.
1.
USING ACCESSORY DRIVE (1, BAR ENGINE (2) OVER. STOP ENGINE ROTATION WHEN ANY
FUEL INJECTOR FOLLOWER JUST BEGINS ITS DOWNWARD STROKE. NOTE NUMBER OF THIS
CYLINDER.
3-194
