19.
20.
21.
22.
NOTE
Make sure all old gasket eliminator has been removed
cover and camshaft bearing cap no. 7 mating surfaces.
TM 9-2320-363-34-1
from rear camshaft
If performing step 19 in vehicle, gasket eliminator is to be applied to cover.
APPLY THIN BEAD OF GASKET ELIMINATOR TO CAMSHAFT BEARING CAP (8) NO. 7 MATING
SURFACE AND INSTALL CAMSHAFT BEARING CAP (8) NO. 7 ON CYLINDER HEAD (24).
INSTALL REAR CAMSHAFT COVER (25) AND THREE BOLTS (26). TIGHTEN BOLTS TO 22-28
(30-38 N.m).
LB-FT
NOTE
Make sure locating tangs are correctly positioned.
INSTALL FIVE CAMSHAFT BEARING SHELLS (27) IN CAMSHAFT BEARING CAPS (8) NO. 2, NO.
3, NO. 5, AND NO. 6. LUBRICATE.
INSTALL FIVE CAMSHAFT BEARING CAPS (8) ON CORRECT SADDLES ON CYLINDER HEAD (24)
AND INSTALL TWO CAMSHAFT CAP BOLTS (10) HAND-TIGHT IN CAMSHAFT BEARING CAPS
NO. 3 AND NO. 5.
3-181
