TM 9-2320-363-34-1
CAMSHAFT AND BEARINGS REPLACEMENT (CONT)
9.
REMOVE THREE BOLTS (11] AND CAMSHAFT GEAR PILOT (12) FROM CAMSHAFT DRIVE GEAR
ACCESS OPENING (13).
C A U T I O N
Clean shop towel may be inserted into gear housing assembly opening to
trap bolts in case they are dropped. Do not allow towel to drop into gear
housing assembly to prevent damage to equipment.
NOTE
Make sure camshaft, dowel is engaged.
10. INSTALL TWO BOLTS (14), TIGHTEN BOLTS ALTERNATELY TO DRAW THRUST PLATE STRAIGHT
INTO GEAR HOUSING ASSEMBLY. TIGHTEN BOLTS TO 22-28 LB-FT (30-38 N.m).
3-178
