TM 9-2320-363-20-1
ABS WIRING HARNESS CONNECTOR CONTINUITY CHECK
NOTE
All ABS wiring harness connectors are located in vehicle cabby ECU (see wiring diagram. page
3-100.52).
1. Coninuity check with connctors atached.
(a) Probe points A and B.
(b) If no open is detected, continue with trouble-
shooting procedures
(c) If an open is detected, separate connectors
by Lifting UP male side of connector over the
notch on the female side and pull connectors
apart.
2. Continuity check with connectors separated.
(a) Female side check. Check continuity of
female side by probing with one lead the
side where wire is installed in connector and
probing with second lead inside receptacle.
(1) Continuity is detected. Check the con-
tinuity of the male side [subparagraph
(b)].
(2) continuity is not delected. Repair wire
and/or replace terminal end. Test wire
to ensure mat continulty exists.
a. if continuity exists, continue with troubleshooting procedures.
b. If continuity does not exist, perform subparagraph (b).
(b) Male side check. Check continuity of male
side by probing with one lead the side where
wire is installed in connector and probing
with second lead inside receptacle.
(1) Continuity is detected. Continue with
toroubleshooting procedures.
(2) Continuity is not detected. Repair wire
and/or replace terminal end. Test wire
to ensure that continuity exists.
Continue with troubleshooting proce-
dures.
Change 2
3-100.7
