TM 9-2320-302-34
0082 00-14
REAR-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0082 00
ASSEMBLY - CONTINUED
NOTE
•
If installing new ring gear and drive pinion, perform steps 19 through 24.
•
Replace ring gear and drive pinion as matched set. Gear set match number is on gear head of drive pin-
ion and front face or outer diameter of ring gear.
•
Pinion cone variation number is used to adjust depth of pinion in differential carrier. Pinion cone varia-
tion number is on end of gear head of drive pinion or outer diameter of ring gear.
17.
Record new pinion cone variation number.
18.
Record old pinion cone variation number.
19.
If old pinion cone variation number is +, subtract number from shim pack thickness in disassembly step 21.
20.
If old pinion cone variation number is -, add number to shim pack thickness in disassembly step 21.
21.
If new pinion cone variation number is +, add number to shim pack thickness determined in step 19 or 20.
22.
If new pinion cone variation number is -, subtract number form shim pack thickness determined in step 19 or 20.
NOTE
•
If installing same ring gear and drive pinion, use shim pack removed in disassembly step 21.
•
If installing new shim pack, use at least three shims with thickest shim in middle of pack.
23.
Aline oil slots on shim pack (22) with oil slots on differential carrier (1) and install shim pack.
1
22
