TM 9-2320-302-34
0082 00-12
REAR-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
0082 00
ASSEMBLY - CONTINUED
11.
Multiply reading from step 9 by radius from step 10 to determine preload. New pinion drive gear preload must be 5-45
lb-in (0.56-5.08 Nm). Used pinion drive gear preload must be 10-30 lb-in (1.13-3.39 Nm).
12.
If preload is not within limits, install thicker spacer (26) to decrease preload or thinner spacer to increase preload.
13.
Repeat steps 7 through 12 until correct preload is obtained.
14.
Coat outside of new oil seal (24) and bore of bearing cage (23) with GAA.
26
24
23
APPLY GAA