TM 9-2320-302-340071 00-43TRANSMISSION OVERHAUL - CONTINUED0071 00MODULE OVERHAUL - CONTINUEDControl Valve Module Disassembly - Continued NOTESolenoid retention pins (19) must be removed from bottom of solenoid body. Note grooved end of pin forpositive retention.11.Remove face seal (20), two solenoids (21), and one solenoid (22) by removing retention pins (19).12.Remove three smaller o-rings (23) and three larger o-rings (24). Remove three solenoid regulator valves (25) and threesprings (26).13.Check resistance of each solenoid. Resistance must be 2-5 ohms.14.Remove valve retention pin (27), stop (28), valve (29), and spring (30) from rotating clutch solenoid body (12).NOTEStationary clutch solenoid body disassembly procedures are steps 15 through 20.15.Remove two seals (31) from stationary clutch solenoid body (14).NOTESolenoid retention pin (32) must be removed from bottom of solenoid body. Note grooved end of pin forpositive retention.16.Remove three solenoid retention pins (32) from bottom of solenoid body (14).17.Remove three solenoids (33), six o-rings (34), three solenoid regulator valves (35), and three springs (36).18.Check resistances of solenoids. Resistance must be 2-5 ohms.19.Remove valve retention pin (37), stop (38), spring (39), and valve (40).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
