TM 9-2320-302-34
0071 00-39
TRANSMISSION OVERHAUL - CONTINUED
0071 00
MODULE OVERHAUL - CONTINUED
Rear Cover and P3 Planetary Module Assembly - Continued
11.
Install indexing ring (10) and retaining ring (9).
12.
Measure pinion end play. Pinion end play must not exceed 0.037 in (0.94 mm). Check all four pinions.
13.
Place P3 planetary carrier assembly (4) on work bench with output shaft up. Place rear cover (3) over output shaft.
14.
If removed, install cone and roller bearing (5) into rear cover assembly (3) using drive sleeve tool J37034.
15.
Install new lock nut retainer (1).
CAUTION
Over-tightening bearing retainer lock nut will damage cone and roller bearing assembly.
16.
Install bearing retainer lock nut (2). Tighten lock nut to 55-65 lb-ft (74-88 Nm).
4
4
9
7
6
2
1
5
8
23
19
18
20
21
22
3
16
17
10
11
13
12
15
14
