TM 9-2320-302-34
0052 00-4
ALTERNATOR REPAIR - CONTINUED
0052 00
DISASSEMBLY - CONTINUED
10.
Remove two screws (29) and capacitor (30).
11.
Remove two screws (31), lock washers (32), washers (33), insulating washers (34), positive rectifier (35), and negative
rectifier (36). Discard lock washers.
12.
Remove two insulator bushings (37) from positive rectifier (35) and negative rectifier (36).
NOTE
Note position of insulator bushings in slip ring end housing prior to disassembly to aid in assembly.
13.
Remove two insulator bushings (38) from slip ring end housing (23).
14.
Remove six nuts (39), three washers (40), insulator (41), three insulators (42), three terminal studs (43), and insulator
(44).
15.
Remove tenz nut (45) and washer (46) from each of three terminal studs (43). Discard tenz nuts.
16.
Remove inner seal (47) and bearing (48). Discard seal and bearing.
17.
Remove seal (49) from rear of slip ring end housing (23) by tapping equally in all five holes on outside of slip ring end
housing. Discard seal.
18.
Remove rotor and drive end housing (21) from shaft (50).
19.
Remove four screws (51), bearing retainer (52), seal (53), and bearing (54). Discard seal.
23
45
46
43
44
49
48
47
38
36
34
33
32
31
29
30
40
42
39
41
35
37
