TM 9-2320-302-34
0047 00-2
FUEL INJECTOR SOLENOID REPLACEMENT
0047 00
REMOVAL - CONTINUED
NOTE
Load plate and spacer plate are matched to injector and must be retained for new solenoid.
2.
Remove four screws (3), load plate (4), and follower retainer (5) from solenoid (6). Discard screws.
3.
Remove solenoid (6) from fuel injector body (7).
4.
Remove spacer (8) and two seals (9) from fuel injector body (7). Discard seals and retain spacer.
INSTALLATION
1.
Install two new seals (9) and spacer (8) on fuel injector body (7).
2.
Position solenoid (6) on spacer (8) and fuel injector body (7).
3.
Install four new screws (3) through load plate (4), follower retainer (5), solenoid (6), and spacer (8).
4.
Thread four screws (3) into body and tighten all screws until heads contact follower retainer (5) and load plate (4).
5.
Tighten screws (3) to 19 lb-in (2 Nm), following sequence shown.
6.
Connect fuel injector harness wiring terminals (2) and tighten two screws (1).
3
5
4
6
9
8
9
7
D
B
A
C
TIGHTENING SEQUENCE
