TM 9-2320-302-34
0046 00-5
FUEL INJECTOR REPLACEMENT - CONTINUED
0046 00
INSTALLATION
NOTE
Perform steps 1 through 10 for each injector being installed.
1.
Lubricate three new o-ring seals (12 and 13) lightly with clean ethylene glycol.
2.
Install larger o-ring seal (12) in upper groove.
3.
Install two lower o-ring seals (13) in two lower grooves.
CAUTION
Ensure injector port is free of dirt or other foreign matter which may cause damage to engine.
4.
Insert injector (11) into cylinder head (3) and visually align injector for equal clearance between valve springs.
5.
Press down on top of injector body until injector (11) is fully seated.
6.
Install holddown clamp (10) on injector (11).
7.
Install and hand tighten washer (9) and holddown bolt (8), with beveled side facing engine.
10
8
9
9
