TM 9-2320-302-34
0044 00-2
3K TURBOCHARGER WASTEGATE ACTUATOR MAINTENANCE - CONTINUED
0044 00
REMOVAL - CONTINUED
4.
Remove bolt (10) and hose clip (11).
5.
Remove bolt (12), two washers (13), and hose connector (14) from turbocharger (9).
6.
Remove hose clip (15) and hose (16) from hose connector (14).
INSTALLATION
1.
Install hose (16) and hose clip (15) to hose connector (14).
2.
Install bolt (12), two washers (13), and hose connector (14) to turbocharger (9).
3.
Secure hose (16) to turbocharger (9) with hose clip (11) and bolt (10).
4.
Coat three bolts (8) with high temperature antiseize compound.
5.
Position wastegate (3) on turbocharger (9) and hand tighten three bolts (8).
6.
Secure hose (2) to wastegate (3) with hose clamp (1).
7.
Loosen jamnut (17) on actuator rod (5).
8.
While holding turbocharger lever (7) down (closed), turn end of actuator rod (5) until hole in rod aligns with stud (6) on
turbocharger lever.
9.
Secure actuator rod (5) end to stud (6) on turbocharger lever (7) with retaining ring (4).
10.
Turn actuator rod (5) end five revolutions in direction of wastegate (3) and tighten jamnut (17).
11.
Tighten three bolts (8) to 180 lb-in (20 Nm).
10
11
16
9
14
12
13
15
