TM 9-2320-302-34
0026 00-5
CAMSHAFT AND BEARINGS REPLACEMENT - CONTINUED
0026 00
REMOVAL - CONTINUED
11.
If there is doubt of camshaft acceptability, determine extent of camshaft lobe wear as follows:
a.
Using set of 0.0015-0.010 in (0.038-0.254 mm) thickness gages (17) and piece of square, hard material (18), mea-
sure flats on injector rise side (19) of camshaft lobes (4).
b.
If flats measure less than 0.003 in (0.076 mm) in depth, but there are no other camshaft defects, camshaft is satis-
factory.
19
17
18
4
REAR VIEW
