TM 9-2320-302-20
0187 00-5
HOOD ADJUSTMENT - CONTINUED
0187 00
ADJUSTMENT- CONTINUED
NOTE
When performing step 24, amount of spacers must be equal under both hood mounting brackets. DO
NOT use more than 3/4 in (19 mm) of spacers.
24.
Using pry bar, raise front of hood (1) enough to insert or remove spacers (16) as needed to make gap between hood and
cowl (2) equal, as measured in step 22.
25.
Repeat step 22.
26.
Tighten two lock nuts (6) to 85 lb-ft (115 Nm).
NOTE
When performing step 27, be extremely careful to prevent movement of locator brackets (15).
27.
Carefully tilt hood (1) to fully open position.
28.
Measure distance between centerline of bolt (10) and outboard face of hood guide (14). Distance must be 2-5/8 in (67
mm). If necessary, move hood guide (14) to obtain correct measurement.
29.
Tighten four lock nuts (4) to 178 lb-in (20 Nm).
30.
Tighten lock nut (5) to 70 lb-ft (95 Nm).
31.
Repeat steps 29 and 30 for opposite side.
END OF WORK PACKAGE
16
6
5
4
10
14
2 5/8 in (67 mm)
15
