TM 9-2320-302-20
0187 00-1
HOOD ADJUSTMENT
0187 00
THIS WORK PACKAGE COVERS
Adjustment Check, Adjustment
INITIAL SETUP
Tools and Special Tools
Tool kit, general mechanic’s (Item 36, WP 0236 00)
Bar, wrecking (Item 3, WP 0236 00)
Wrench, torque, 0-300 lb-in (Item 44, WP 0236 00)
Wrench, torque, 50-250 lb-ft (Item 46, WP 0236 00)
Materials/Parts
Nut, lock (P/N MS 51922-33) (2)
Nut, lock (P/N MS 51922-9) (8)
Shim(s) (P/N 17-10320-001)
Personnel Required
Two
References
TM 9-2320-302-10
ADJUSTMENT CHECK
NOTE
Perform steps 1 through 3 to determine if hood adjustment is necessary.
1.
Measure and note gap between rear edge of hood (1) and cowl (2) at seam and at 8 in (203 mm) below seam. Gap should
be 1/2-3/4 in (13-19 mm).
2.
Check that front of hood (1) is centered with bumper (3). Check that space between top edge of bumper (3) and lower
edge of hood (1) is equal at both ends.
3.
Ensure that hood (1) is not touching any components attached to frame. If any components are touching hood, identify
and correct problem, and repeat steps 1 and 2.
1/2-3/4 in (13-19 mm)
Clearance
Both Sides
Equal
Seam
3
2
3
1
1
