TM 9-2320-273-20
FUEL AND AIR INTAKE SYSTEM
4-21. ACCELERATOR PEDAL AND ROD MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
14. Locknut ( 15) and flatwasher
(14).
15. Two bolts (36) and Iockwashers
(35).
Unscrew and remove fork (37)
and nylon flanged bushing
(33).
Unscrew and remove throttle
mounting bracket (34).
B. INSTALLATION.
16. Throttle mounting bracket (34).
17. Nylon flanged bushing (33) and
fork (37).
18. Spring (28).
19. Nuts (24) and (26) along
with ball stud (23) and (27),
20. Ball stud (27).
21. Ball stud (23).
22. Bellcrank bracket (42).
23. Flanged bearing (41 ) and
(43).
24. Pivot lever (40).
Position against side of engine
and install with two bolts (36)
and Iockwashers (35).
Attach to throttle mounting
bracket (34) with flat washer
(14) and locknut (15).
Hook to bracket (31), located
at fuel pump lever (32), and
to throttle mounting bracket (34).
Screw onto bellcrank rod (25).
Screw on the same num-
ber of threads you
counted in step A 11.
a. Insert threaded end thru
bracket (31 ).
b. Attach with washer (30) and
nut (29).
a. Insert threaded end thru
lever (20).
b. Attach with washer (22)
and nut (21 ).
Attach to cab with four bolts
(44), flat washers (45) and nuts
(46).
Position in either end of guide
tube in bellcrank bracket (42).
a. Insert threaded end thru
flanged bearing (41 ), bell-
crank bracket (42), flanged
bearing (43) and lever (20).
b. Secure with flat washer (17)
and locknut (16).
4-60
