TM 9-2320-273-20
FUEL AND AIR INTAKE SYSTEM.
4-21. ACCELERATOR PEDAL AND ROD MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
2. Two bolts (5), Iockwashers
Unscrew and remove bracket
and nuts (18).
(6).
3. TWO bolts (8), Iockwashers
Unscrew and remove pedal stop
(12), and nuts (13).
bracket (11 ),
4. Bolt (9) and two nuts (10).
Unscrew and remove from
Count number of threads
pedal stop bracket (11 ).
before disassembly.
5. Three screws (50).
Unscrew and remove seal
retainer (48) and accelerator
seal (47).
6. Cotter pin (39).
Remove and pull out clevis pin
Discard cotter pin (39).
(38); lift out rod (49).
7. Locknut (16) and flat
Unscrew and remove pivot
washer (17).
lever (40), flanged bearing
(41 ), and flanged bearing (43).
8. Four bolts (44), flat washers
Unscrew and remove bellcrank
(45) and nuts (46).
bracket (42).
9. Spring (19).
Unhook from lever (20) and
attachment point to cab at
other end of spring,
10. Nut (21 ) and washer (22).
Unscrew and remove lever (20).
11. Nut (29) and washer (30).
Unscrew from ball stud (27).
Remove items (23 thru
(27) as an assembly.
Count number of threads
before disassembly to
maintain idle speed set-
ting.
12. Ball stud (23) and (27)
Unscrew from bellcrank rod
along with nuts (24) and (26).
(25).
13. Spring (28).
Unhook from bracket (3)
located at fuel pump lever
(32), and from throttle
mounting bracket (34).
4-58
