TM 9-2320-273-20
STEERING AND ALINEMENT.
10-23. AUXILIARY CYLINDER (M916 THRU M920) (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
5. Two fittings (14).
Unscrew and remove.
6. Cotter pin (22).
Remove and throw away.
7. Nut (23).
Remove.
8. Ball joint (1).
Remove from steering arm (24), Tap out with hammer.
9. Rubber boot (25).
Lift out of steering arm (24).
10. Cotter pin (18).
Remove and throw away.
11. End cap (15), spring (16),
Unscrew end cap (15) and
and outer ball cup (17).
remove cap, spring, and outer
ball cup.
12. Cylinder (5).
Line up ball portion of slot
with head of ball joint (19)
and remove from ball. Set
cylinder (5) with ball joint
(1) and clamp (3) on bench.
13. Inner ball cup (17).
Remove from cylinder (5).
14. Nut (21) and washer
Remove from back side of
(20).
ball joint (19) stud.
15. Ball joint (19).
Remove from frame mounting
plate.
16. Clamp nut (2).
See NOTE below, then unscrew
from clamp bolt (4) and remove
clamp (3).
NOTE
Before proceeding with step (17), count number
of threads showing between ball joint (1) and
cylinder (5) on cylinder shaft for installation.
17. Ball joint (1).
Unscrew from shaft on cylinder
(5).
B. INSPECTION.
18. Ball joint (1).
Inspect for wear.
Replace as necessary.
19. Ball joint (19).
Inspect for wear.
Replace as necessary.
20. Steering arm (24).
Inspect for wear.
Replace as necessary.
10-98
