TM 9-2320-273-20
STEERING AND ALINEMENT.
10-23. AUXILIARY CYLINDER (M916 THRU M920) (Continued).
LOCATION/lTEM
ACTION
REMARKS
C. INSTALLATION.
25. Ball joint (1).
Screw onto shaft of cylinder
Screw on shaft until same
(5).
number of threads that were
showing on disassembly are
showing now.
26. Clamp (3).
Slide over ball joint arm and
secure with clamp bolt (4) and
clamp nut (2).
27. Ball joint (19).
SIide joint stud through the
frame mounting plate. Use
mallet if necessary.
28. Nut (21) and washer (20).
a. Screw onto stud of ball joint
(19) and tighten.
b. Apply GAA to ball.
29. Inner ball cup (17).
a. Apply GAA to cup surface.
b. Slide into cylinder end until
seated with cup surface
facing out.
30. Cylinder (5).
Line up ball portion of slot
and slide over ball joint (19).
31. Rubber boot (25).
Place in steering arm (24).
Small end down.
32. Ball joint (1).
Insert in steering arm (24).
33. Nut (23).
Screw on until tight, then
advance nut for cotter pin
hole alinement.
34. New cotter pin (22).
Insert through hole in stud of
ball joint (1) and bend tabs
over.
35. Outer ball cup (17),
a. Apply GAA to ball face of
spring (16) and end
cup (17) outer.
cap (15).
b. insert outer cup into cylin-
der with cup face inward
toward ball (19).
c. Slide Spring (16) into cylinder
and seat against outer cup
flat face.
d. Screw in cap (15) until flush.
e. Aline cap slot with next
cotter pin hole in cylinder.
10-100
