TM 5-2330-325-13&P
0085
ASSEMBLY - Continued
3.
Align tool box cover (Figure 2, Item 4) and clamp hinges in position.
WARNING
The following must be done before grinding, cutting, or welding any equipment that
has been Chemical Agent Resistant Coating (CARC)-coated:
Wear protective equipment (e.g., eye protection, gloves, apron) when
grinding or sanding CARC-coated equipment. DO NOT leave any
skin exposed.
Use high-efficiency air purifying respirators when grinding or sanding
CARC-coated before welding.
Never weld or cut CARC-coated equipment; grind or sand off CARC paint
completely before welding.
Failure to comply may result in death or injury to personnel. Seek medical
attention in the event of an injury.
Unsafe welding practices can cause serious injury from fire, explosions, or harmful
agents. Allow only authorized personnel to weld or cut metals. Protective clothing,
eye protection, and respirator must be worn; adequate protective equipment used,
a suitable fire extinguisher kept nearby; and requirements of TC 9-237 strictly
followed. Failure to comply may result in death or injury to personnel. Seek
medical attention in the event of an injury.
CARC paint contains Hexamethylene Diisocyanate (HDI) which is highly irritating
to skin and respiratory system. High concentrations of HDI can produce symptoms
of itching and reddening of skin. A burning sensation in throat, and nose and
watering of the eyes. In extreme concentrations HDI can cause coughing,
shortness of breath, pain during respiration, increased sputum production, and
chest tightness. Failure to comply may result in death or injury to personnel. Seek
medical attention in the event of an injury.
CAUTION
When welding, semitrailer must be uncoupled from towing vehicle. Failure to comply may
result in damage to, or destruction of, equipment or mission.
NOTE
Check alignment of tool box cover to tool box before completing welding procedure.
4.
Weld tool box cover (Figure 2, Item 4) hinges to tool box cover.
5.
Install handle (Figure 2, Item 2), two bolts (Figure 2, Item 1), washers (Figure 2, Item 20), and new
self-locking nuts (Figure 2, Item 19).
6.
Install two brackets (Figure 2, Item 7), four bolts (Figure 2, Item 5), eight washers (Figure 2, Item 6), and
four new self-locking nuts (Figure 2, Item 11).
7.
Tilt and lower tool box floorboard (Figure 2, Item 18) in place.
0085-4
02/13/2013root(maintwp)wpno(M1053)
