TM 5-2330-325-13&P
FIELD MAINTENANCE
GENERAL MAINTENANCE INSTRUCTIONS
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
Tool Kit, General Mechanic's
Solder, Lead (WP 0143, Table 1, Item 23)
(WP 0144, Table 1, Item 16)
Solvent, Cleaning Compound
Cutting and Flaring Kit, Tube
(WP 0143, Table 1, Item 26)
(WP 0144, Table 1, Item 2)
Tag, Marker (WP 0143, Table 1, Item 28)
Gloves, Chemical and Oil Protective
Tape, Antiseizing (WP 0143, Table 1, Item 29)
(WP 0144, Table 1, Item 7)
Tape, Duct (WP 0143, Table 1, Item 30)
Tubing, Heat Shrinkable
(WP 0143, Table 1, Item 32)
Materials/Parts
Adhesive, Loctite (WP 0143, Table 1, Item 1)
References
Brush, Scrub (WP 0143, Table 1, Item 5)
Brush, Wire (WP 0143, Table 1, Item 6)
TB 43-209
Detergent, General Purpose
TC 9-237
(WP 0143, Table 1, Item 8)
TM 9-214
Flux, Soldering (WP 0143, Table 1, Item 9)
TM 43-0139
Oil, Lubricating (WP 0143, Table 1, Item 19)
Rag, Wiping (WP 0143, Table 1, Item 21)
WARNING
Accidental or intentional introduction of liquid contaminants into the environment is a
violation of state, federal, and military regulations. Refer to Army Petroleum, Oils, and
Lubricants (POL) for information concerning storage, use, and disposal of these liquids.
Use a drain pan or appropriate containment equipment to capture any draining or leaking
fluid. Refer to local procedures and plans for preventing and responding to fluid spills or
leaks. Comply with local regulations when disposing of clean up material and leaked and
spilled fluids. Failure to comply may cause damage to environment and health of
personnel. Failure to comply may result in death or injury to personnel. Seek medical
attention in the event of an injury.
0051-1
02/13/2013root(gen.maintwp)wpno(M1011)