M1070 HET ARMOR KIT
II113400
Rev. D
3.
Install escape hatch mount assemblies as follows (see Figure 3-86):
a. Install four escape hatch mount assemblies onto four corners of opening in rear panel and secure each
with two screws (1), lock washers (2), and flat washers (3). Tighten but do not torque screws.
b. Match-drill two 3/16-inch pilot holes through each of four escape hatch mount assemblies.
c. Remove four escape hatch mount assemblies by removing two screws (1), lock washers (2), and
flat washers (3) from each.
d. Enlarge eight pilot holes to ∅19/64 inch.
e. Install eight threaded inserts (4).
f.
Re-install four escape hatch mount assemblies onto four corners of opening in rear panel and secure each
with four screws (1), lock washers (2), and flat washers (3). Torque screws to 32 lb-inch.
INSTALLATION 3-174
JUNE 2005