M1070 HET ARMOR KIT
II113400
Rev. D
2. Install windshield assembly armor as follows (see Figure 3-83):
a. Apply a ∅3/8-inch thick bead of black urethane sealant (1) around the perimeter of the window cut out.
b. Install one windshield assembly armor (2) onto previously installed windshield mount Z-channel and
install two side windshield mount Z-channels (3) and one upper windshield mount Z-channel (4) and
secure each with the remaining 16 bolts (5), 32 flat washers (6), and 16 lock nuts (7). Torque lock nuts to
9 lb-ft.
NOTE
Urethane sealant must be applied to the bolt locations on the upper
Z-channels in order to achieve a proper environmental seal.
c. Wipe and clean excessive urethane sealant after installation and cut away excess urethane sealant after it
cures sufficiently.
d. Repeat Step 2 on opposite side.
INSTALLATION 3-166
JUNE 2005