M1070 HET ARMOR KIT
II113400
Rev. D
4. Adjust door as follows (see Figure 3-80):
NOTE
The object of this door adjustment procedure is to center the door striker in the
latching mechanism. The latch can be centered in up / down direction by
loosening Bolts A, as shown in Figure 3-80. The latch can be centered in the
fore / aft direction by loosening Bolts B, as shown in Figure 3-80. The latch may
also be shimmed out from the door skin by adding more washers between the
latch and door for each of the bolts labeled "B". This can help to prevent or fix a
problem with the door sticking.
a. Disconnect spring from window support.
b. Loosen Bolts A (as shown in Figure 3-80) and adjust latching mechanism as required to center striker in
the latching mechanism.
NOTE
Latch must be centered so that it contacts both the upper and lower dovetails on
the striker mounting plate at approximately the same time.
c. Torque Bolts A (as shown in Figure 3-80) to 18 lb-ft.
d. Loosen Bolts B as shown in Figure 3-80) and adjust latching mechanism as required to center striker in
the latching mechanism.
e. Torque Bolts B (as shown in Figure 3-80) to 35 lb-ft.
f.
Adjust the clevis end that attaches the latch to the door rod by disconnecting the clevis and turning it
down or up in order to ensure the latch opens when the handle is turned. The handle has a limited range
of motion, so this must be done carefully.
g. Reconnect spring to window support.
NOTE
The latching mechanism is a two-stage latch. Ensure proper is engagement is
possible for both positions.
h. Repeat process as required to ensure proper engagement of latching mechanism to striker and that the
handle opens the latch without difficulty.
i.
Repeat Step 4 on opposite side of vehicle.
INSTALLATION 3-158
JUNE 2005