M1070 HET ARMOR KIT
II113400
Rev. D
3. Install door striker and door striker support as follows (see Figure 3-79):
a. Install striker and striker mounting plate (provided with door assembly) onto "B" pillar using existing nut
in "B" pillar.
b. Position and align striker support (1) against bottom of striker mounting plate and transfer two hole-
locations to "B" pillar.
c. Remove door striker support (1) from "B" pillar.
d. Drill two ∅17/32-inch holes through first wall of "B" pillar.
e. Install two upset nuts (2) into "B" pillar.
f.
Install door striker support (1) and secure with two screws (3). Torque to 23 lb-ft.
g. Repeat Step 3 on opposite side of vehicle.
INSTALLATION 3-156
JUNE 2005