M1070 HET ARMOR KIT
II113400
Rev. D
a. Installation
1. Pre-assemble and install left mine blast panel as follows (see Figure 3-62):
a. Raise the left mine blast panel (1) into place under vehicle using a forklift or other suitable lifting device.
NOTE
This operation requires sufficient space between the vehicle and the left mine
blast panel (1) to install bottom front bracket (2).
b. Prior to raising the panel completely up against the vehicle frame, install one bottom front bracket (2)
onto left mine blast panel (1) and secure with one bolt (3), two flat washers (4), and one locknut (5).
Torque locknut to 35 lb-ft.
NOTE
This operation requires significant teamwork and communication in order to
properly align and position the slots and holes in the left mine blast panel (1).
c. Align slots in left mine blast panel (1) with all previously installed brackets and raise left mine blast panel
into place.
d. Apply Loctite to threads of one bolt (6).
e. Secure left mine blast panel (1) to vehicle with one bolt (6) and one flat washer (4); one bolt (3),
two flat washers (4), and one locknut (5); four bolts (7), eight flat washers (4), and four locknuts (5); and
eight locknuts (5) and flat washers (4). Torque all bolts and locknuts to 23 lb-ft.
INSTALLATION 3-118
JUNE 2005
