M1070 HET ARMOR KIT
II113400
Rev. D
3. Match-drill doghouse as follows (see Figure 3-41):
a. Remove eight screws securing the top surface of doghouse floor panel. Do not remove doghouse floor
panel.
b. Install doghouse bottom panel (1) onto doghouse floor panel and temporarily secure with eight bolts (2).
Tighten bolts for temporary use.
c. Remove 12 screws securing doghouse back-wall panel. Do not remove doghouse back-wall panel.
d. Install doghouse panel (3) against doghouse back-wall panel and secure with 12 bolts (2). Tighten bolts
for temporary use.
NOTE
As necessary, temporarily remove the transmission shift box and ventilation
louvers located on top of the doghouse console, as they may interfere with this
installation inside the doghouse. Re-install during final assembly.
e. Using doghouse bottom panel (1) and doghouse panel (3) as templates, match-drill twelve 9/32-inch holes
through outer left and right row of holes in both armor panels and through cab skin panels.
f.
Remove all 20 bolts, doghouse bottom armor panel (1), and doghouse armor panel (3) from vehicle.
INSTALLATION 3-80
JUNE 2005