M1070 HET ARMOR KIT
II113400
Rev. D
6. Pre-assemble doghouse right panel assembly as follows (see Figure 3-44):
a. Install one doghouse forward bracket (1) onto doghouse right panel (2) and secure with three bolts (3),
three flat washers (4), and three locknuts (5). Torque locknuts to 35 lb-ft.
b. Install two stud plates (6) onto doghouse right panel (2) and secure each with only one flat washer (4) and
locknut (5) (at the bottom studs as shown). Torque locknut to 23 lb-ft.
NOTE
Doghouse forward bracket (1) may be installed after the doghouse right panel
assembly is installed on the vehicle (after Step 7), as it may ease the process of
installation, since this is a very tight area for assembly.
INSTALLATION 3-84
JUNE 2005