M1070 HET ARMOR KIT
II113400
Rev. D
a. Installation
1. Match-drill doghouse floor panel as follows (see Figure 3-39):
a. Install one upper doghouse bracket (1) into position against the doghouse floor panel, aligning two back
slots in the bracket (1) with two middle holes in floor panel and secure with two bolts (2). Tighten bolts
for temporary use.
b. Using upper doghouse bracket (1) as a template, match drill three 1/2-inch holes into the vertical step of
the doghouse floor panel.
c. Remove two bolts (2) and upper doghouse bracket (1) and set aside for future use.
2
1
Match-drill (3) holes through
step of floor panel using
bracket as template.
Figure 3-39. Match-Drill Doghouse Floor Panel.
JUNE 2005