TB 9-2320-360-13&P-2
RIGHT CAB SIDE (FRONT) ARMOR AND DOOR HINGE MAINTENANCE - CONTINUED
0026 00
ASSEMBLY
NOTE
Make sure cab side armor is assembled in correct order and has correct orientation. Thicker armor panel (18)
is installed on the outside of the thinner armor panel (17).
1.
Assemble bracket (14), hinge (19), outer side armor panel (18), and inner side armor panel (17).
2.
Install 12 bolts (15), washers (23), and new locknuts (22) on hinge (19). Tighten locknuts to 35 lb-ft (48 Nm).
3.
Install bolt (16), washer (21), and new locknut (20) on hinge (19). Tighten locknut to 35 lb-ft (48 Nm).
4.
Install engine cover latch (24), two washers (26), bolts (25), washers (36), and new locknuts (35). Tighten locknuts to 11
lb-ft (15 Nm).
5.
Install bracket (34), three washers (28), and new locknuts (27).
6.
Install step bracket (31), two washers (33), bolts (32), washers (30), and new locknuts (29). Hand-tighten locknuts.
7.
Install trim seal on inner side armor panel (17) from top of bracket (14) to top of panel (17).
16
15
17
18
19
14
20,21
22,23
35,36
34
32,33
24
31
27,28
25,26
29,30
417-104
0026 00-4