TB 9-2320-360-13&P-2
REAR CAB ARMOR MAINTENANCE - CONTINUED
0025 00
INSTALLATION
1.
Install sling and lifting device to lifting eyes (21).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Rear cab armor weighs 445 lb (202 kg).
2.
Using lifting device, install rear cab armor (6) on vehicle.
3.
Install six washers (19) and new locknuts (18) on rear cab armor (6). Tighten locknuts to 23 lb-ft (31 Nm).
4.
Install nine washers (8) and new locknuts (7) on rear cab armor (6). Tighten locknuts to 23 lb-ft (31 Nm).
5.
Install six washers (5) and new locknuts (4) on rear cab armor (6). Tighten locknuts to 23 lb-ft (31 Nm).
6.
Install three roof panel brackets (3), 12 washers (2), and new locknuts (1) on rear cab armor (6). Tighten locknuts to 23
lb-ft (31 Nm).
7.
Install two spacers (9), washers (10), bolts (11), washers (12), and new locknuts (13) on bottom edge of rear cab armor
(6).
8.
Install grab handle (20), four bolts (17), washers (15), and new locknuts (14) on rear cab armor (6).
3
1,2
4,5
6
21
20
18,19
7,8
14,15,16,17
417-102
9,10,11
12,13
(HIDDEN)
0025 00-4