TB 9-2320-360-13&P-2
REAR CAB ARMOR MAINTENANCE - CONTINUED
0025 00
DISASSEMBLY
1.
Remove six nuts (22) and two antenna mounts (23) from rear cab armor (6).
2.
Remove 12 locknuts (34), washers (35), three brackets (24), and stud plates (25) from rear cab armor (6). Discard lock-
nuts.
3.
Remove two locknuts (32), washers (33), lifting eyes (21), bolts (26), and washers (27) from rear cab armor (6). Discard
locknuts.
4.
Remove eight locknuts (30), washers (31), screws (28), and two light brackets (29) from rear cab armor (6). Discard
locknuts.
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
ASSEMBLY
CAUTION
DO NOT over torque locknuts on stud plates. Failure to follow this caution may cause damage to studs.
1.
Install two light brackets (29), eight screws (28), washers (31), and new locknuts (30) on rear cab armor (6).
2.
Install two lifting eyes (21), washers (27), bolts (26), washers (33), and new locknuts (32). Tighten locknuts to 35 lb-ft
(48 Nm).
3.
Install three brackets (24), stud plates (25), 12 washers (35), and new locknuts (34) on rear cab armor (6). Tighten lock-
nuts to 23 lb-ft (31 Nm).
4.
Install two antenna mounts (23) and six nuts (22) on rear cab armor (6). Tighten nuts to 27 lb-ft (37 Nm).
23
24
25
22
21
26,27
34,35
28
32,33
6
417-103
30,31
29
0025 00-3
