TB 9-2320-360-13&P-1
A/C COMPRESSOR - RECEIVER/DRYER WIRING HARNESS REPLACEMENT - CONTINUED
0047 00
INSTALLATION
N OT E
Refer to WP 0057 00, Figure j., for electrical schematic.
A/C compressor-receiver/dryer harness can be fed through grommet in doghouse by accessing the harness
through the removed alternator access panel.
Install plastic ties as required.
1.
Route A/C compressor-receiver/dryer harness (9) through doghouse (15) and grommet (16) on rear engine access panel
of doghouse (17).
2.
Connect A/C compressor-receiver/dryer harness connector (1) to A/C evaporator connector (2).
HETF00463
3.
Close doghouse door (WP 0028 00).
N OT E
Cushion clamps not used on armored vehicles. Install plastic ties as necessary to remove wiring harness.
4.
Install cushion clamp (5) on two A/C hoses (7 and 8) and A/C compressor-receiver/dryer harness (9).
5.
Install cushion clamp (5) on twist bracket (6) with washer (4) and screw (3).
6.
Install cushion clamp (12) on two A/C hoses (7 and 8) and A/C compressor-receiver/dryer harness (9).
7.
Install cushion clamp (12) on A/C cushion clamp bracket (13) and firewall (14) with washer (11) and screw (10).
HETF00466
0047 00-4