TB 9-2320-360-13&P-1
A/C ENGINE FAN CONTROL SOLENOID REPLACEMENT - CONTINUED
0026 00
INSTALLATION
WAR N I N G
Adhesives and sealing compounds can burn easily, can give off harmful vapors and are harmful to skin and
clothing. To avoid injury or death, keep away from open fire and use in well-ventilated areas. If adhesive or
sealing compound gets on skin or clothing, wash immediately with soap and water.
N OT E
Keep caps and plugs on hoses and fittings until just prior to installation to prevent contamination.
1.
Install bracket (9) on ECM (11) with screw (10).
2.
Apply sealing compound to fan control solenoid end of two elbows (3 and 5).
3.
Install two elbows (3 and 5) on fan control solenoid assembly (8).
N OT E
Air lines are attached to fan control solenoid assembly loosely to allow flexibility in mounting assembly on
bracket.
4.
Install supply air line (2) on elbow (3).
5.
Install thermostatic switch inlet air line (4) on elbow (5).
6.
Install fan control solenoid assembly (8) on bracket (9) with screw (7) and new locknut (6).
7.
Connect connector (1).
8.
Tighten supply air line (2) on elbow (3).
9.
Tighten thermostatic switch inlet air line (4) on elbow (5).
10.
Start engine and pressurize system (TM 9-2320-360-10).
11.
Shut off engine (TM 9-2320-360-10).
12.
Check for leaks.
13.
Close hood (TM 9-2320-360-10).
14.
Remove wheel chocks (TM 9-2320-360-10).
END OF WORK PACKAGE
0026 00-3/(0026 00-4 Blank)
