TB 9-2320-335-13&P
10-23.1. ENGINE LEFT SPLASH SHIELD MAINTENANCE
(SERIAL NUMBERS 300000 AND ABOVE)
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic's tool kit:
TM 9-2320-387-24-1
automotive (Appendix B, Item 1)
TB 9-2320-335-13&P, Appendix E
Maintenance and repair shop equipment:
Equipment Condition
automotive (Appendix B, Item 2)
Battery ground cables disconnected
Materials/Parts
(TM 9-2320-387-24-1).
Eight locknuts (Appendix A, Item 76)
Hood prop rod and bracket removed
Nut and lockwasher assembly
(TM 9-2320-387-24-1).
(Appendix A, Item 134)
General Safety Instructions
Four rivets (Appendix A, Item 262.1)
Locknut (Appendix A, Item 106)
Hood must be supported during removal and
Three locknuts (Appendix A, Item 82)
installation.
Four lockwashers (Appendix A, Item 172)
Maintenance Level
Lockwasher (Appendix A, Item 145)
Unit
WARNING
Hood must be supported during removal and installation. Failure
to support hood may cause injury to personnel or damage to
equipment.
a. Removal
1.
Disconnect hood harness (1) from connector (2).
2.
Remove four capscrews (27), lockwashers (28), and washers (29) from plate (31) and splash shield
bracket (9). Discard lockwashers (28).
3.
Remove capscrews (34) and (36), plate (31), and spring nuts (30) and (37) from headlight
housing (35).
4.
Remove four nuts (33), capscrews (32), and connector (2) from plate (31).
5.
Remove nut and lockwasher assembly (5), capscrew (6), and harness and clamp assembly (4) from
splash shield (3). Discard nut and lockwasher assembly (5).
6.
Remove nut (7) and valve (8) from splash shield (3).
7.
Remove locknut (38), washer (39), capscrew (24), and washer (25) from support bracket (26) and
splash shield (3). Discard locknut (38).
8.
Remove capscrew (23), lockwasher (22), and washer (21) from airlift bracket (10) and
splash shield (3). Discard lockwasher (22).
9.
Remove locknut (11), washers (12) and (13), capscrew (19), and washer (18) from lower airlift
bracket (20) and splash shield (3). Discard locknut (11).
10.
Remove locknut (14), capscrew (17), and washer (16) from master cylinder bracket (15). Discard
locknut (14) and remove splash shield (3) from vehicle.
10-2