TB 9-2320-335-13&P
7-5.1. MASTER CYLINDER REPLACEMENT
(SERIAL NUMBERS 300000 AND ABOVE) (Cont'd)
b. Installation
CAUTION
Perform master cylinder bleeding procedure before installing
master cylinder on vehicle. Damage to master cylinder may
result if bleeding is not done properly (para. 7-2.1).
Ensure O-ring is properly seated in master cylinder prior to
installation or damage to master cylinder may occur.
1.
Install master cylinder (4) on hydro-booster (15) with O-ring (16), splash shield bracket (1), two
locknuts (14), bracket (13), two washers (12), and locknuts (11). Tighten locknuts (11) and (14) to
22 lb-ft (30 Nm).
2.
Install bracket (10) on bracket (13) with capscrew (8), lockwasher (7), and washer (6).
3.
Install left and right front brake lines (5) on proportioning valve (9) and master cylinder (4).
4.
Install vent hose (2) on reservoir cap (3).
2
1
3
16
4
15
5
14
6
7
13
8
12
11
9
10
FOLLOW-ON TASKS: Install left splash shield (para. 10-23.1).
Connect battery ground cables (TM 9-2320-387-24-1).
Bleed brake system master cylinder (para. 7-2.1).
7-11