Freightliner M915 / M916 -
Installation Manual P/N 0257550622-00
Crew Protection Kit
(Doc No.: II113500-1 D)
7. M915-A2 and M916-A1 Specific Installation Steps
This chapter provides additional and replacement instructions, accompanied with illustrations, on how
to install certain kit subassemblies for the M915-A2 and M916-A1 that differ in design from the M915-
A3 models. Instructions should be followed in the sequence described in Chapter 5 with the steps
contained within this chapter substituted were specified.
In order to install the Crew Kit 0257000000-00 (113500-1) on the M915-A2 or M916-A1, the installer
will also need the M915-A2 and M916-A1 Adaptation Kit, 113502-1. Its contents are described in
Table 3.4.
7.1 Prep work for Cab Support installation (M916-A1 Only)
Perform this step prior to Step 5.1 in the main installation sequence.
7.1.1 Parts, Fasteners, Special Tools, and Materials
Parts (see Figure 7-2, 7-3, and 7-4):
Alternate
Find No. in
Part No.
Part No.
Description
Procedure
Quantity
113508-1
Strap, Hose Support
#508
1
0093200
Wrap, Hose
#200
3 ft
Fasteners: (see Figure 7-4)
Find No.
Description
Size
Quantity
57
Screw, Button Head Cap
1/4" x 1"
2
62
Nut, Self-locking, NC
1/4"
2
Special Tools:
Description
Vendor/Part-Number
Standard pipe wrench
1. Disconnect the P-clips that hold the low-pressure hydraulic hoses that feed the pump
located on the transmission (These hoses are indicated in Figure 7-1).
2. Turn the low-pressure hydraulic line elbows connected to the pump on the transmission in
a clockwise fashion (tightening) up to 1/8 turn to achieve more clearance under the hoses
for the cab support (see Figure 7-1). Access to these elbows is best achieved through the
removable panel on the floor beneath the shift tower.
3. Install 8" to 9" of protective hose wrap part # 200 to each hose in the area indicated in
Figure 7-2. After the cab support is installed, the position of the wrap may be adjusted to
provide protection against wear from the support.
Page 109 of 125
