Freightliner M915 / M916 -
Installation Manual P/N 0257550622-00
Crew Protection Kit
(Doc No.: II113500-1 D)
Figure 5-6. Installing the RH Wheel Housing
Placing the RH Wheel Housing Support Arm.
5) Lift item #006 into position as shown in Figure 5-6a. Insert the aft-most bolts first
(item 22). Temporarily use the aft-most fasteners to hold the deflector in position. Install the
center and forward fasteners next (do not tighten the bolts until all fasteners are in place).
Apply thread-locking compound to each bolt. Install fasteners in the following order:
Star-Washer
Flat-Washer
Insert bolt from beneath
Nut.
6) Tighten bolts to a 122 N-m (90 ft-lb) torque.
7) Ensure that the flexible brake lines are not rubbing on the inside lower edge of the Wheel
Zone Deflector (#006). If the lines are rubbing are near the Wheel Zone Deflector, relocate
them by loosening the hose end fitting, twisting the lines and then re-tightening the hose end
fittings.
WARNING
Ensure that the flexible brake lines are not rubbing on the inside lower edge of the
Wheel Zone Deflector (#006). If the lines are rubbing are near the Wheel Zone
Deflector, reposition the hose path by loosening the hose end fitting, twisting the lines,
and then re-tightening the hose end fittings