Freightliner M915 / M916 -
Installation Manual P/N 0257550622-00
Crew Protection Kit
(Doc No.: II113500-1 D)
Fasteners (see Chapter 6 for fasteners map)
Size
Quantity
Find No.
Description
(P/N in Procedure - last 3
digits)
22
Bolt
1/2" x 1-3/4"
6
41
Bolt
5/8" x 2-1/2"
6
35
Star-Washer
1/2"
6
42
Star-Washer
5/8"
6
34
Flat-Washer
1/2" x 1" x 1/8"
6
43
Flat-Washer
5/8" x 1-1/4" x 1/8"
6
39
Nut
1/2"
6
40
Nut
5/8"
4
Special Tools:
Description
Vendor/Part-Number
Lifting device capable of lifting
Commercial
approximately 110 Kg (242 lb)
LIFT HAZARD
Use proper lifting device with capacity of no less that 110 kg (242 lb) to lift the wheel
housing kit.
5.2.2 Installation Instructions
1) Arrange parts and fasteners at the installation location.
2) Prepare a lifting device capable of lifting approximately 110 kg (242 lb).
3) Place part #658 on the front bumper. Align item #970 with the front bumper outboard edge
(see Figure 5-6).
4) Connect part #658 with part #970 using six (6) 5/8" x 2-1/2" bolts, 5/8" Star-Washers,
5/8" x 1-1/4" x 1/8" Flat-Washers, and 5/8" nuts. Arrange fasteners in the following order:
Bolt, Star-Washer, Flat-Washer, Bracket Assembly, and Nut. Install all 6 bolts and
associated nuts and washers. Tighten the top 3 bolts first, and then tighten the lower 3
bolts. Torque to 230 Nm (170 ft-lb). Note: Thread-locking compound must be used on
these fasteners.
IMPORTANT
Raise the rear end of part #970 as high as possible before connecting with part
#658.
Page 27 of 125
