TB 9-2320-279-13&P
0040
2. Install 6433258-01M1 or 6433258-200M1 right front panel assembly (12) and secure to
right lower side panel assembly (1) with two 4397000-382 capscrews (16), 4397004-009
lockwashers (15), 4397005-017 washers (14), and 4397064-007 locknuts (13) as shown
in figure 5. Do not tighten locknuts (13) at this time.
CAU T I ON
Limit drilling depth to avoid possible damage to equipment
behind area being drilled.
3. Clamp front panel assemblies (9 and 12) in place as required, and match drill six 15/32
inch diameter holes through each front panel assembly (9 and 12) as shown in figure 5.
4. Repair finish all edges that have been drilled using appropriate primer specified per
MIL-C-53072.
5. Secure each front panel assembly (9 and 12) with six 4397000-382 capscrews (11),
4397004-009 lockwashers 10), 4397005-017 washers (2), and 4397064-007 locknuts (3)
as shown in figure 5. Tighten locknuts (3) to 60 lb-ft.
F. Install top panel assembly and grab/pull handle as follows:
1. Install 6433286-01M1 or 6433286-200M1 top panel assembly (6) and 6433300-02M1 or
6433300-200M1 shackle opening cover (17), and secure to left upper side panel assembly
(9) with five 4397000-381 capscrews (1), 4397004-009 lockwashers (13), and 4397005-
016 washers (16) as shown in figure 6. Do not tighten capscrews (1) at this time.
2. Secure top panel assembly (6) to right upper side panel assembly (7) with five 4397000-
381 capscrews (2), 4397004-009 lockwashers (3), and 4397005-016 washers (14) as
shown in figure 6. Do not tighten capscrews (2) at this time.
3. Secure top panel assembly (6) to rear panel assembly (8) with four 4397000-381
capscrews (4), 4397004-009 lockwashers (5), and 4397005-016 washers (15) as shown in
figure 6. Do not tighten capscrews (4) at this time.
4. Install 6433120-01M1 grab/pull handle (10) and secure with two 4397000-036 capscrews
(12) and 4397004-007 lockwashers (11) as shown in figure 6. Do not tighten capscrews
(12) at this time.
G. Install wheelwell armor as follows:
1. Install 6433113-01M1 or 6433113-200M1 left wheelwell assembly (7) and secure to left
front panel assembly (8) with one 4397000-382 capscrew (10), 4397004-009 lockwasher
(9), 4397005-017 washer (22), and 4397064-007 locknut (21) installed in center
mounting hole as shown in figure 7. Do not tighten locknut (21) at this time.
0040-8
