TB 9-2320-279-13&P
0040
8. If necessary, rotate clamp (17) and bracket (14) to align slotted hole in bracket (14) with
mounting holes in pump module center support (16) and center support or rear panel
assembly (11). Tighten two locknuts (15) to 37 lb-ft. Refer to figure 2.
9. Install 4397000-072 capscrew (5), two 4397005-015 washers (2), and 4397064-005
locknut (1) as shown in figure 2. Do not tighten locknut (1) at this time.
10. Remove locknut (22) and star washer (21) from capscrew (20) in static reel mount (19) as
shown in figure 2.
11. Route ground strap (8) under pump module (3) and up through floor grate (18) near static
reel mount (19). Refer to figure 2.
12. Install ground strap (8) on capscrew (20) and secure with star washer (21) and locknut
(22) as shown in figure 2. Tighten locknut (22) to 37 lb-ft.
C. Install lower side panel assemblies as follows:
1. Install 6433059-01M1 or 6433059-200M1 left lower side panel assembly (31) and route
lamp wiring harness connector (29) through hole near upper rear corner as shown in
figure 3.
2. Secure lower rear edge of left lower side panel assembly (31) to rear panel assembly (16)
with two 4397000-382 capscrews (19),4397004-009 lockwashers (18), and 4397005-016
washers (17) as shown in figure 3. Do not tighten capscrews (19) at this time.
3. Install two 4397000-041 capscrews (26), 4397004-007 lockwashers (28), and 4397005-
013 washers (27) as shown in figure 3. Do not tighten capscrews (26) at this time.
4. Install 3286740 tanker light grommet (30) in left lower side panel assembly (31) and snap
wiring harness into grommet (30). Refer to figure 3.
5. Install 4397000-382 capscrew (22), 4397004-009 lockwasher (21), and 4397005-016
washer (20) in upper rear edge of left lower side panel assembly (31) as shown in figure
3. Do not tighten capscrew (22) at this time.
6. Install 4397000-041 capscrew (23), 4397004-007 lockwasher (24), and 4397005-013
washer (25) as shown in figure 3. Do not tighten capscrew (23) at this time.
7. Install 6433058-01M1 or 6433058-200M1 right lower side panel assembly (1) and route
lamp wiring harness connector (15) through hole near upper rear corner as shown in
figure 3.
8. Secure lower rear edge of right lower side panel assembly (1) to rear panel assembly (16)
with two 4397000-382 capscrews (12), 4397004-009 lockwashers (13), and 4397005-016
washers (14) as shown in figure 3. Do not tighten capscrews (12) at this time.
0040-6
